No More Room in Hell 2 Raven Rock Keycard & Fuse Locations: Red Keycard and Industrial Fuses

Finding the Red Keycard and both Industrial Fuses is one of the biggest progression hurdles in No More Room in Hell 2's Raven Rock map. The keycard opens the route through Sector A, while the two Industrial Fuses are required to repair the Substation power circuit and start the generator.

The important catch is that item locations can vary between matches, so you should treat the locations below as reliable areas to search rather than guaranteed coordinates.

This guide covers where to look for the Red Keycard, both Industrial Fuses, how to use them, and what to do if you cannot find them.

A tactical infographic layout showing Raven Rock search zones for the Red Keycard in Sector A administrative offices and two Industrial Fuses in Sector C maintenance areas, including a generator puzzle slotting diagram and a horde warning notice for No More Room in Hell 2.

Table of Contents


Raven Rock Keycard & Fuse Locations at a Glance

ItemWhere to SearchPurpose
Red KeycardSector A administrative/security areasOpens the required security access
Industrial Fuse #1Sector C maintenance/supply areasRepairs the Substation circuit
Industrial Fuse #2Sector C lower maintenance/flooded areasRepairs the Substation circuit
2 Industrial FusesSector CRequired to start the Substation Generator
⚠️ Important: The exact desk, shelf, crate, or container can change between matches. The locations described here are based on the areas where these items can be found, not guaranteed static spawn points.

⬆ Back to Table of Contents

Where to Find the Red Keycard

The Red Keycard is found after entering the B1 section and reaching the Sector A administrative area.

Look through the offices, security desks, cubicles, and nearby work areas for the red access card.

Red Keycard Search Route

After opening the B1 Blast Door:

  1. Enter Sector A.
  2. Search the administrative offices and security areas.
  3. Check desks and nearby surfaces carefully.
  4. Look for the distinctive red keycard.
  5. Pick it up and continue toward the locked security access point.
Red Keycard location: Sector A administrative/security area.
Spawn warning: The exact location can vary between matches.

The most important thing is not to search only one particular desk. If the card isn't where you expect it to be, thoroughly check the surrounding office area.

⬆ Back to Table of Contents

How to Use the Red Keycard

The process is straightforward:

  1. Find the Red Keycard in Sector A.
  2. Carry it to the locked security access point.
  3. Interact with the card reader.
  4. Allow the security door to unlock.
  5. Continue toward Sector B.

If the reader says that clearance is required, you probably haven't found the correct keycard yet.

πŸ’‘ Red Keycard Tip: Don't waste time searching the B1 entrance itself. Once you've reached Sector A, search the office and security areas systematically. Check desks, shelves, counters, and other obvious item surfaces before moving deeper into the facility.

⬆ Back to Table of Contents

Where to Find Industrial Fuse #1

After progressing through Sector B and reaching the lower industrial areas, Raven Rock's next major blocker is the Substation power circuit.

The generator cannot be started until you find two Industrial Fuses.

The first fuse can be found somewhere within the Sector C maintenance/supply areas.

Fuse #1 Search Area

Start by checking:

  • Maintenance rooms
  • Supply areas
  • Shelving
  • Open storage crates
  • Workbenches
  • Utility rooms

In the observed route, the first Industrial Fuse was found inside a green metal supply crate on a storage shelf.

Industrial Fuse #1: Sector C maintenance/supply area.
Spawn warning: The exact container or shelf can vary between matches.

If you enter Sector C and don't immediately see the fuse, don't assume it isn't there. Search the surrounding maintenance rooms and storage spaces before moving deeper into the complex.

⬆ Back to Table of Contents

Where to Find Industrial Fuse #2

The second Industrial Fuse is also located in Sector C, but you may need to travel farther into the lower maintenance areas.

Search the:

  • Lower utility corridors
  • Maintenance rooms
  • Storage crates
  • Tool carts
  • Shelving
  • Flooded or partially flooded passages

In the observed route, the second fuse was found near a lower maintenance/flooded passage, resting around the area's storage equipment.

Industrial Fuse #2: Lower Sector C maintenance/utility area.
Spawn warning: The exact crate or surface can vary between matches.
⚠️ Don't Leave Sector C Too Early
One of the easiest mistakes is finding one fuse and assuming the second one will be nearby. It may not be. Once you've found the first fuse, continue searching deeper into the Sector C maintenance network until you have both.

⬆ Back to Table of Contents

How to Repair the Substation Power Circuit

Finding the fuses is only half the puzzle.

Once you have both:

  1. Return to the Substation Generator area.
  2. Locate the generator's power control panel.
  3. Insert the first Industrial Fuse.
  4. Insert the second Industrial Fuse.
  5. Confirm that both fuse slots are filled.
  6. Interact with the generator starter.

This completes the REPAIR SUBSTATION POWER CIRCUIT objective.

After the circuit is repaired, the generator can be started.

⚠️ Prepare Before Starting the Generator
Don't immediately pull the starter. Starting the Substation Generator creates a major zombie threat, so your squad should prepare first.

Before activating it:

  • Reload every firearm.
  • Heal wounded teammates.
  • Check ammunition.
  • Make sure everyone knows where the escape route is.
  • Position teammates near defensible entrances.
  • Keep your strongest close-range weapons ready.
  • Avoid having one player separated deep inside a side room.

Once the generator starts, the resulting noise attracts zombies and can turn the area into a dangerous close-quarters fight.

⬆ Back to Table of Contents

What to Do If You Cannot Find a Keycard or Fuse

If an objective item isn't where you expect it to be, don't immediately assume the match is bugged. Raven Rock's important loot should be approached as an area search rather than a single-coordinate search.

If the Red Keycard Is Missing

Search:

  • Sector A offices
  • Security desks
  • Office cubicles
  • Shelves
  • Counters
  • Nearby administrative rooms

The biggest mistake is checking one desk and leaving.

If an Industrial Fuse Is Missing

Search the entire relevant Sector C maintenance section.

Check:

  • Open crates
  • Shelves
  • Tool carts
  • Workbenches
  • Utility rooms
  • Lower corridors
  • Flooded maintenance areas

Still Can't Find It?

Have two squad members search different branches while maintaining enough distance to respond if a horde appears. Avoid sending one player completely alone into the deeper tunnels.

⬆ Back to Table of Contents

Best Squad Strategy for Searching Raven Rock

Raven Rock becomes much easier when the squad divides responsibilities without completely splitting up.

1. Keep a Search Pair Together

Two players can search while the other two cover nearby corridors. This gives the squad enough coverage without creating isolated targets.

2. Call Out Every Item

When someone finds a fuse or keycard, communicate its location immediately. This prevents another player from wasting time searching the same rooms.

3. Don't Ignore Containers

Important objective items aren't necessarily sitting in the middle of a room.

Check:

  • Crates
  • Shelves
  • Desks
  • Workbenches
  • Tool carts
  • Storage areas

4. Return as a Group

Once both fuses are collected, regroup before returning to the generator. The generator activation is one of the most dangerous transitions in the map.

5. Prepare for the Next Objective

After starting the generator, your squad will eventually need to retrieve and transport the Heavy Radio Transponder. Don't burn all your ammunition and healing items searching for the fuses.

⬆ Back to Table of Contents

Common Keycard & Fuse Mistakes

Mistake #1: Treating One Desk as the Keycard Spawn

Problem: You search one desk and conclude the Red Keycard isn't present.

Fix: Search the wider Sector A administrative/security area.

Mistake #2: Searching Only the Generator Room for Fuses

Problem: The generator tells you that components are missing, but you can't find them.

Fix: Leave the generator room and thoroughly search the Sector C maintenance and storage areas.

Mistake #3: Finding One Fuse and Stopping

Problem: One Industrial Fuse is installed, but the generator still won't start.

Fix: You need two Industrial Fuses.

Mistake #4: Starting the Generator Immediately

Problem: The squad gets overwhelmed as soon as the generator starts.

Fix: Reload, heal, regroup, and establish defensive positions before activating it.

Mistake #5: Splitting the Squad Too Far Apart

Problem: One player finds a fuse but gets overwhelmed before the others can reach them.

Fix: Search in pairs or maintain clear lines of communication between squad members.

⬆ Back to Table of Contents

Raven Rock Keycard & Fuse FAQ

Where is the Red Keycard in Raven Rock?

The Red Keycard can be found in the Sector A administrative/security area. Search desks, cubicles, security stations, and nearby surfaces. The exact spawn can vary between matches.

What is the Red Keycard used for?

The Red Keycard is used at the appropriate security door reader to unlock the next section of Raven Rock and continue toward Sector B.

How many Industrial Fuses are needed in Raven Rock?

You need two Industrial Fuses to repair the Substation power circuit.

Where are the Industrial Fuses?

Both are found in the broader Sector C maintenance and utility areas. Search supply crates, shelves, work areas, and lower maintenance corridors. Exact item positions can vary.

Can Industrial Fuse locations change?

Yes. Treat the locations described in this guide as search areas rather than guaranteed static spawns.

Why won't the Raven Rock generator start?

If the generator cannot be activated, make sure both Industrial Fuses have been installed into the Substation power panel.

Should I start the generator as soon as I find both fuses?

No. Reload, heal, regroup, and establish defensive positions first. Generator activation creates a significant zombie threat.

What comes after the Industrial Fuses?

After repairing and starting the Substation Generator, the squad progresses toward Sector D Silo, retrieves the Heavy Radio Transponder, and eventually carries it to the Cargo Lift for extraction.

⬆ Back to Table of Contents

Final Tips for Raven Rock

The key to Raven Rock's item hunt is searching the correct area rather than memorizing one supposedly permanent spawn.

  • Red Keycard: Search Sector A administrative/security areas.
  • Industrial Fuse #1: Search Sector C maintenance and supply areas.
  • Industrial Fuse #2: Search deeper Sector C utility/maintenance areas.
  • Need two fuses: Both are required for the Substation circuit.
  • Before generator activation: Reload, heal, and regroup.
  • Don't search alone: Raven Rock's tight corridors make isolated players easy targets.

Once the Substation is powered, you're through one of Raven Rock's biggest progression blockers—but the map's most dangerous objectives are still ahead.

⬆ Back to Table of Contents


Related Guides & Sources

⬆ Back to Table of Contents

Comments